Question 711 · 1003 in bank
Which option works with a DHCP server to return at least one WLAN management interface IP address during the discovery phase and is dependent upon the VCI of the AP?
Show answer
Answer: B
350-401ProfessionalCiscoAll questions freePage 72 of 101
350-401 practice questions 711–720
Implementing Cisco Enterprise Network Core Technologies (ENCOR)1,003 questions across 101 pages are complete and free, with no account or card.
Official study references
1003 questions in this bank
Free access · progress saved on this device
Question 712 · 1003 in bank
Refer to the exhibit.
PC 2 cannot communicate with PC 4. Which configuration resolves this issue?
Show answer
Answer: C
Question 713 · 1003 in bank
A customer has 20 stores located throughout a city. Each store has a single Cisco AP managed by a central WLC. The customer wants to gather analytics for users in each store. Which technique supports these requirements?
Show answer
Answer: B
Explanation
Wrong. Problem states that each store has only one (1) AP. Hyperlocation requires multiple APs to work. If you read further down, you'll find this: "A general rule of thumb is to have 3 or 4 access points that are within line of sight of the device at a distance of less than 70 feet."
Source: Adapted from community discussion — JackDRipper
References
Question 714 · 1003 in bank
Which statement describes the IP and MAC allocation requirements for virtual machines on Type 1 hypervisors?
Show answer
Answer: C
Question 715 · 1003 in bank
Refer to the exhibit.
Two switches are interconnected using interface GigabitEthernet0/0 on both sides. While configuring one of the switches, a network engineer receives the logging message. Which action resolves this issue?
Show answer
Answer: C
Explanation
Who the F chose B? Are you high? Why would you want BPDUs sent on an access port? Yes C is the answer, but you also have to remove bpduguard on the port and shut/no shut to bring it back up. so D is also an answer but only after you do C first.
Source: Adapted from community discussion — mgiuseppe86
Question 716 · 1003 in bank
By default, which virtual MAC address does HSRP group 12 use?
Show answer
Answer: A
Question 717 · 1003 in bank
Refer to the exhibit.
An engineer configures a new WLAN that will be used for secure communications; however, wireless clients report that they are able to communicate with each other. Which action resolves this issue?
Show answer
Answer: B
Explanation
The Answer IS NOT A Client exclusions only matter for when client authenticates, it has nothing to do with Secure Communication. More info on Client Exclusions: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_01001011.pdf The Anwer is B https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_01001011.pdf
Source: Adapted from community discussion — Clauster
References
Question 718 · 1003 in bank
Refer to the exhibit.
What happens to access interfaces where VLAN 222 is assigned?
Show answer
Answer: C
Explanation
Because VLAN 222 is an RSPAN VLAN, any access interfaces that are assigned to VLAN 222 will be placed into an inactive state. This means that they will not forward any traffic, except for traffic that is specifically destined for the switch.
Source: Adapted from community discussion — shefo1
References
Question 719 · 1003 in bank
Refer to the exhibit.
Which command is required to validate that an IP SLA configuration matches the traffic between the branch office and the central site?
Show answer
Answer: D
Explanation
Question says to "validate" that the configuration matches the traffic - D, sh ip sla statistics has the counters that show the "matched" traffic.
Source: Adapted from community discussion — Jeff555566
References
Question 720 · 1003 in bank
Select 2Refer to the exhibit.
The administrator must extend the configuration of the switch to perform remote logging using syslog according to these requirements: • syslog server: 203.0.113.11 reachable through Gi0/0 • initial message severity: notifications • message transport: reliable Which two commands must be added to the configuration to accomplish this goal? (Choose two.)
Show answer
Answer: BD
Explanation
This question applies to Catalyst 3850 SWITCH. Answer is BD not BC. logging host 203.0.113.11 vrf Mgmt-vrf transport tcp - changed from udp to tcp logging trap notifications - change from informational to notification/notice logging source-Interface GigabitEthernet0/0 vrf Mgmt-vrf - will be used by default. Gig0/0 will most probably be the only interface on the switch in VRF mgmt hence no need to configure this one.
Source: Adapted from community discussion — eww_cybr
Keyboard:J Kmove between questionsA–Dselect an answerRshow or hide the answer← →change page
350-401 practice, question 711. 1003 questions available.
About this question bank
Version 1.0.0. How we source questions