200-301 practice questions 391–400

1. Question 391 · 1334 in bank

   DRAG DROP - Drag and drop the IPv6 address type characteristics from the left to the right. Select and Place:

   

   This is an interactive task on the real exam — a drag-and-drop, hotspot or ordering question. There is nothing to select here, so the answer is shown below for reference.

   Show the answer figure

   Answer: See figure below

   Explanation

   Wrong. I think the answer should be: Link Local Address: - Attached to a single subnet - Addressing for exclusive use internally without internet routing Unique Local Address: -Addresses with prefix FC00:/7 -Configured only once per interface

   Source: Adapted from community discussion — no_blink404

   

   Next question

2. Question 392 · 1334 in bank

   Which protocol does Ansible use to push modules to nodes in a network?

   • ATelnet
   • BKerberos
   • CSNMP
   • DSSH

   Show answer

   Answer: D

   Next question

3. Question 393 · 1334 in bank

   Which function does an iterative DNS query serve in the domain name resolution process?

   • AObtain information directly from all root DNS servers configured within the scope.
   • BEncrypt communication automatically between DNS clients and servers.
   • CAllow a DNS client to contact several DNS servers until the correct information is found.
   • DUpdate records dynamically across multiple DNS servers at the same time.

   Show answer

   Answer: C

   Next question

4. Question 394 · 1334 in bank

   What is the difference between controller-based networks and traditional networks as they relate to control-plane and/or data-plane functions?

   • AController-based networks centralize all important data-plane functions, and traditional networks distribute data-plane functions.
   • BTraditional networks centralize all important control-plane functions, and controller-based networks distribute control-plane functions.
   • CTraditional networks centralize all important data-plane functions, and controller-based networks distribute data-plane functions.
   • DController-based networks centralize all important control-plane functions, and traditional networks distribute control-plane functions.

   Show answer

   Answer: D

   Explanation

   D. Controller-based networks centralize all important control-plane functions, and traditional networks distribute control-plane functions. In traditional networks, control-plane functions (such as routing decisions) are distributed across network devices like routers. In controller-based (software-defined) networks, these functions are centralized in a controller, which manages and controls the network devices.

   Source: Adapted from community discussion — exiledwl

   Next question

5. Question 395 · 1334 in bank

   Why choose Cisco DNA Center for automated lifecycle management?

   • Ato allow SSH access to ail nodes in the network
   • Bto provide software redundancy in the network
   • Cto perform upgrades without service interruption
   • Dto provide fast and accurate deployment of patches and updates

   Show answer

   Answer: D

   Next question

6. Question 396 · 1334 in bank

   What is the default interface for in-band wireless network management on a WLC?

   • Aout-of-band
   • Bredundant port
   • Cservice port
   • Dwireless management

   Show answer

   Answer: D

   Next question

7. Question 397 · 1334 in bank

   Which factor must be considered during the implementation of an IPsec VPN?

   • AIn IPsec tunnel mode, the entire original IP datagram is encrypted.
   • BIPsec transport mode increases GRE tunnel security over tunnel mode.
   • CIn IPsec tunnel mode, only the IP payload is encrypted.
   • DIPsec transport mode leaves the Layer 4 header unencrypted for inspection.

   Show answer

   Answer: A

   Explanation

   10.16.24 today. I passed mine a few days ago using the questions up to here. The questions on my exam matched the old objectives, not the CCNA "V1." I saw Puppet and Chef questions, but none about Terraform. Use the dump questions wisely. The user comments are valuable.

   Source: Adapted from community discussion — DingoHunter

   Next question

8. Question 398 · 1334 in bank

   An engineer must configure a /30 subnet between two routes. Which usable IP address and subnet mask combination meets this criteria?

   • Ainterface e0/0 description to XX-AXXX:XXXXX ip address 10.2.1.3 255.255.255.252
   • Binterface e0/0 description to XX-AXXX:XXXXX ip address 192.168.1.1 255.255.255.248
   • Cinterface e0/0 description to XX-AXXX:XXXXX ip address 172.16.1.4 255.255.255.248
   • Dinterface e0/0 description to XX-AXXX:XXXXX ip address 209.165.201.2 225.255.255.252

   Show answer

   Answer: D

   Explanation

   First poit is /30 subnet is 255.255.255.252.so we can filter out A and C. Let find the block size---> 256-252=4 From 4 IPs one for network and one for broadcast.Two usable IPs remain. So 209.165.201.0 is the network and 209.165.201.2,209.165.201.3 are the usable IPs. So 209.165.201.2 is a useble IP with 255.255.255.252 subnet mask. Answer is D.

   Source: Adapted from community discussion — Samitha

   Next question

9. Question 399 · 1334 in bank

   DRAG DROP - Drag and drop the characteristics of transport layer protocols from the left onto the corresponding protocols on the right. Select and Place:

   

   This is an interactive task on the real exam — a drag-and-drop, hotspot or ordering question. There is nothing to select here, so the answer is shown below for reference.

   Show the answer figure

   Answer: See figure below

   Explanation

   Given answers are correct. UDP does not use sequence numbers, it is unable to re-order datagrams that it receives in the wrong order.

   Source: Adapted from community discussion — [Removed]

   

   Next question

10. Question 400 · 1334 in bank

    A network engineer must configure an interface with IP address 10.10.10.145 and a subnet mask equivalent to 11111111.11111111.11111111.11111000. Which subnet mask must the engineer use?

    • A/29
    • B/30
    • C/27
    • D/28

    Show answer

    Answer: A

    Explanation

    The subnet mask equivalent to 11111111.11111111.11111111.11111000 in dotted decimal notation is 255.255.255.248. To determine the appropriate subnet mask for the given IP address and subnet mask, we need to identify the number of bits in the network portion of the address. In this case, the first 29 bits of the IP address are used for the network portion, and the remaining 3 bits are used for the host portion. Therefore, the correct subnet mask is /29.

    Source: Adapted from community discussion — Isuzu

    Next question

Keyboard:J Kmove between questionsA–Dselect an answerRshow or hide the answer← →change page

200-301 practice, question 391. 1334 questions available.