VMware NSX 4.x Professional (VCP-NV)83 questions across 9 pages are complete and free, with no account or card.
83 questions in this bank
Free access · progress saved on this device
An NSX administrator is creating a Tier-1 Gateway configured in Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original failed node to become the Active node upon recovery. Which failover policy meets this requirement?
Answer: B
Which CLI command is used for packet capture on the ESXi Node?
Answer: C
Which command on ESXi is used to verify the Local Control Plane connectivity with Central Control Plane?
Answer: D
Which two commands does an NSX administrator use to check the IP address of the VMkernel port for the Geneve protocol on the ESXi transport node? (Choose two.)
Answer: C
Which two statements describe the characteristics of an Edge Cluster in NSX? (Choose two.)
Answer: BD
An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fail. The administrator knows the maximum transmission unit size on the physical switch is 1600. Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?
Answer: A
vmkping is the command used to test network connectivity for VMware kernel ports (vmk interfaces). The ++netstack=geneve option specifies that the Geneve (Generic Network Virtualization Encapsulation) protocol is being used. Geneve is the protocol used in NSX-T for overlay tunneling between ESXi hosts. -d enables the Don't Fragment (DF) bit, which ensures that the packet will not be fragmented. This is important because you're testing with a specific MTU size. -s 1572 sets the packet size to 1572 bytes. This accounts for the overhead of the encapsulation and leaves the packet size of 1600 bytes (the maximum allowed by the physical switch), considering the Geneve header.
Source: Adapted from community discussion — electro165
An NSX administrator is creating a NAT rule on a Tier-0 Gateway configured in active-standby high availability mode. Which two NAT rule types are supported for this configuration? (Choose two.)
Answer: B
Destination NAT is supported, but Tier-0 Gateways in active-standby HA mode have specific limitations regarding dynamic or stateful destination NAT configurations. Some more complex forms of DNAT may not work as expected in HA mode. In active-standby HA mode on a Tier-0 Gateway, the supported NAT rule types are: 1:1 NAT Source NAT (SNAT)
Source: Adapted from community discussion — electro165
When deploying an NSX Edge Transport Node, what two valid IP address assignment options should be specified for the TEP IP addresses? (Choose two.)
Answer: AC
Which two built-in VMware tools will help identify the cause of packet loss on VLAN Segments? (Choose two.)
Answer: BD
A customer has a network where BGP has been enabled and the BGP neighbor is configured on the Tier-0 Gateway. An NSX administrator used the get gateways command to retrieve this information:
Which two commands must be executed to check BGP neighbor status? (Choose two.)
Answer: AE
Keyboard:J Kmove between questionsA–Dselect an answerRshow or hide the answer← →change page
2V0-41.24 practice, question 31. 83 questions available.
Version 1.0.0. How we source questions