Implementing Cisco Advanced Call Control and Mobility Services (CLASSP)211 questions across 22 pages are complete and free, with no account or card.
211 questions in this bank
Free access · progress saved on this device
An administrator is configuring Cisco UCM and wants all inbound calls to the company’s published DID number to ring on the receptionist's internal directory number. Which configuration step meets this requirement?
Answer: A
A collaboration engineer is configuring call pickup for a Cisco UCM user that currently has a working BLF speed dial button for the teammate’s extension. The user wants to see calls ringing on the teammate's extension and to answer those calls by pressing the BLF speed dial button. Which configuration step meets this requirement?
Answer: B
A company has users that frequently visit locations outside the office. These users need to be able to make calls and keep the company integrity by presenting a company caller ID. The users are equipped with company-paid mobile phones. The company uses Cisco UCM with Cisco Unified Border Element and Expressway-C and Expressway-E for external communications. Which technology must be configured to meet this requirement?
Answer: B
A newly deployed site in Pennsylvania uses SIP-to-SIP legs on a Cisco Unified Border Element. The administrator wants to match the incoming dial peer based on the calling number. Which configuration is needed in the dial-peer?
Answer: A
An engineer configures several calling party transformation patterns in Cisco UCM so that calling numbers are shown in the +E.164 format. The route patterns match seven-digit internal numbers and prefix the numbers with 1408. The SIP trunk matches 1408XXXXXXX and prefixes the number with +. When users make outbound calls, the calling number still shows as seven digits. What is the cause of this problem?
Answer: C
Refer to the exhibit. A company deploys an additional instance of Cisco UCME named CUCME 2 in a branch office. Phones in the main office are registered with their extension to an instance of Unified CME named CUCME 1. Phones in the branch office are registered with their extension to CUCME 2. The engineer needs to configure CUCME 1 to allow calls from the main office to the branch office using an 8-kbps codec. Which configuration should be applied to CUCME 1?
Answer: D
Users in a small location report that audio calls work fine, but only one video call works before the next one gets a busy signal. Three video conference rooms were recently installed by a third party. The audio and video devices are Cisco endpoints. The site uses video and audio calls, and a network investigation does not show saturation on the link. The site is configured with QoS and CoS. All devices are registered on the headquarters Cisco UCM cluster. What is the cause of this problem?
Answer: D
Refer to the exhibit. An engineer deploys CAC to Cisco UCM. Up to five G.711 calls must be supported on the WAN link between Site A and Site B. Users report that only four concurrent calls are possible between Site A and Site B. Why isn't the fifth concurrent call successful?
Answer: D
Refer to the exhibit. Calls from users to the PSTN in an organization get disconnected with a 408 Request Timeout when the called party is unavailable to pick up the call. Which solution must be used to resolve this challenge?
Answer: D
After a new SIP trunk is configured from a third-party SIP trunk provider, the call does not seem to work. A troubleshooting tool and a trace log from the Cisco Unified Border Element shows that there is communication with the provider and that it is sending out SDP information in the 2XX response. Why is the call not working?
Answer: C
Keyboard:J Kmove between questionsA–Dselect an answerRshow or hide the answer← →change page
300-815 practice, question 181. 211 questions available.
Version 1.0.0. How we source questions