JN0-351 practice questions 101–105

1. Question 101 · 105 in bank

   Select 2

   Which two statements are correct about martian routes? (Choose two.)

   • AMartian routes are never installed in the route table.
   • BAdditional prefixes can be added to the list of martian routes.
   • CMartian routes only represent publicly used prefixes.
   • DMartian routes are always host addresses.

   Show answer

   Answer: AB

   Next question

2. Question 102 · 105 in bank

   Select 2

   You are asked to configure a redundant trunk group (RTG). Which two requirements would accomplish this task? (Choose two.)

   • AThe RTG must be participating in a Spanning Tree topology.
   • BInterfaces within an RTG can be configured as access ports.
   • CInterfaces within an RTG must be configured as trunk ports.
   • DBoth interfaces of an RTG must be configured to service the same VLANS.

   Show answer

   Answer: CD

   Next question

3. Question 103 · 105 in bank

   

   Which command solves the error that you see in the exhibit?

   • Adelete ge-0/0/2 unit 0 family ethernet-switching vlan members default
   • Bset ge-0/0/2 unit 0 family ethernet-switching vlan members [default v11]
   • Cdelete ge-0/0/2 unit 0 family ethernet-switching vlan members all
   • Dset ge-0/0/2 unit 0 family ethernet-switching vlan members all

   Show answer

   Answer: A

   Next question

4. Question 104 · 105 in bank

   Select 2

   You deployed a new EX Series switch with DHCP snooping enabled and you do not see any entries in the snooping databases for an interface. Which two Juniper configurations for that interface caused this issue? (Choose two.)

   • AThe interface is configured as a trunk port.
   • BMAC limiting is enabled on the interface.
   • CDynamic ARP inspection is enabled on the interface.
   • DThe interface is configured as a disabled port.

   Show answer

   Answer: AD

   Next question

5. Question 105 · 105 in bank

   Select 3

   

   Referring to the exhibit, which three statements are correct? (Choose three.)

   • AThe IP source guard is enabled.
   • BDynamic ARP inspection is enabled.
   • CDHCP snooping is enabled.
   • DThe DHCP snooping database is protected.
   • EDHCP snooping is enabled for IPv6 traffic.

   Show answer

   Answer: ABC

Keyboard:J Kmove between questionsA–Dselect an answerRshow or hide the answer← →change page

JN0-351 practice, question 101. 105 questions available.