Cisco Certified Design Expert (CCDE) Written263 questions across 27 pages are complete and free, with no account or card.
263 questions in this bank
Free access · progress saved on this device
Refer to the exhibit. The network 10.10.0.0/16 has been redistributed to OSPF processes and the best path to the destination from R1 has been chosen as R1-R2-R3. A failure occurred on the link between R2 and R3, and the path was changed to R1-R4-R5-R3 What happens when the link between R2 and R3 is restored?
Answer: B
The General Bank of Greece plans to upgrade its legacy, end-of-life WAN network with a new flexible, manageable, and scalable solution. The main requirements are ZTP support, end-to-end encryption, application awareness, and segmentation. The CTO states that the main goal of the bank is CAPEX reduction. Which WAN technology should be used for the solution?
Answer: C
A software-defined networking (SDN) controller learns network topology information by using BGP link-state sessions with the route reflectors of an MPLS-enabled network. The controller then uses the topology information to apply on-demand traffic policies to the network through a protocol that is supported from all Layer 3 routers. Each policy is represented as a RIB entry in the control plane of the router. Which SDN model has been implemented?
Answer: D
Refer to the exhibit. Company XYZ must design a DMVPN tunnel between the three sites. Chicago is going to act as the NHS and the company wants DMVPN to detect peer endpoint failures. Which technology should be used in the design?
Answer: B
A consultant needs to evaluate project management methodologies for a new service deployment on the existing network of a customer. The customer wants to be involved in the end-to-end project progress and be provided with frequent updates. The customer also wants the ability to change the requirements if needed, as the project progresses. Which project management methodology should be used?
Answer: C
Refer to the exhibit. The WAN network of the General Bank of Greece has experienced several outages. It takes too long to activate a new branch site. The networking department of the bank plans to upgrade the legacy end-of-life WAN network with a new flexible, manageable, and scalable in-house solution. The number of branches will increase exponentially in the next fiscal year. The CTO states that the bank’s main goal is OPEX reduction. The network engineering team prepares a table to evaluate the available options. Which WAN technology can be used for the solution?
Answer: A
Refer to the exhibit. After a network audit a network engineer must optimize the current network convergence time. The proposed solution must consider link layer and control plane failures. Which solution meets the requirements?
Answer: C
What are two parameters that can be leveraged by SAML in mixed private/public cloud environments by using identity and asset management? (Choose two.)
Answer: AD
Data replication is being designed as part of a data protection setup to be run over the network. Which replication strategy is best suited when the primary and secondary systems are physically close to each other?
Answer: A
A national retail company is expanding their business by adding several international sites in the next 12 months. With their current IT infrastructure, they face a high number of expenses in managing and maintaining their two current data and voice networks. In addition, the business wants to invest in technologies that offer enhancements to business activities and increase employee productivity. Which two technical requirements should be considered during the network design phase? (Choose two.)
Answer: CE
Keyboard:J Kmove between questionsA–Dselect an answerRshow or hide the answer← →change page
400-007 practice, question 221. 263 questions available.
Version 1.0.0. How we source questions